Collector Box and Electrode Assembly

Twist Lock Collector Box Ignitor Assembly
First install the burner in the grill. Next assemble the collector box electrode parts including the wire as shown below and attach to the burner. Finally attach the round female connector on the wire coming from the electrode to the round male connector on the bottom of the push button.

	1. Place the electrode through the hole on the bottom of the collector box. Taking care to not break the electrode, slide the electrode mounting bracket under the tab on the collector box. This is a tight fit and you may want to open the tab slightly with the screwdriver beforehand.
2. The flat spade connector on the wire slides on and attaches to the bottom of the electrode.
	3. Finally the box mounts flush to the burner with the tab on top. The screw goes into the front hole.